How to install laminate flooring transitions.
Laminate transition top of stairs.
Floating floors transitions and trim complement the flooring and provide a safe durable way to create expansion contraction space between areas and lead to other existing floors in the home.
The risers go on next.
People often ask me how to connect hardwood or laminate floor with staircase installation i always prefer start wood flooring installation from stairs but e.
I m not sure how even that would be with the top stair.
The new stair nose cannot be installed with an overhang.
I m assuming the top stair is 3 4 of an inch thick.
Step 1 examine the carpeted steps.
The riser must come flush with the surface of the tread and the stair nose which goes on last curls around the top of the riser and either fits flush against the laminate.
Or you can have laminate on the stairs and need to finish the carpet up to the top stair of laminate.
Most often the top stair will involve installing a stair nose.
Move back to the transition strip.
The stair nose molding will then cover the top edge of the carpeting.
The international building code specifies a maximum riser height of 7 inches so a single laminate plank usually suffices but you may prefer to use pine poplar or some other stainable wood instead.
Installing a laminate stair nosing over the top step of the carpeted stairs will tie the stairs into the laminate flooring and make the transition look seamless.
Their purpose is to cover the edge of the laminate flooring where it meets another floor or where it will end and still provide the expansion gap that is needed.
Most of the stairs have an overhang that may need to be cut off.
Lay a towel over top of the strip.
I would use a square edge transition and butt the vertical edge of the transition up against the top stair.
There are many situations that you will need to know how to install laminate flooring transitions.
These are very important to use.
Or the space beneath the hang can be filled in with wood.
With the laminate being lower than the top stair its not a good idea to use a t mold as it would be on a slant.
The carpeting should reach up to the top stair riser.